C C++ Programming | PCB Prototype LabJack U3-HV | Hardware Setup

Design and manufacture a printed circuit board (PCB) prototype and write a C program that interfaces together via a LabJack U3-HV.

The purpose of your project is for a piezoelectric buzzer to sound on and an LED to turn on

the optical sensor circuit is interrupted. When the sensor is not interrupted, the green LED output

will be off and the buzzer will be silent. When the sensor is blocked, the green LED output will

turn on and the buzzer will sound on. The sensor state must be read and displayed to the user

every 0.25 s, regardless of its value.

Choose one of the following methods to end your program:

Method 1: Exit program after the alarm has been triggered the fourth time,

OR,

Method 2: Exit program after 15 seconds of continuous running and monitoring.

To test your project, run the code and trigger the alarm several times while the code is running

to see the two outputs change states. The interface should conform to the specs listed.

Schematic Diagram

From the LabJack U3-HV: Select your own input and output channels; use one VS and one GND.

Electrónica Diseño PCB Ingeniería eléctrica Microcontrolador Programación en C

Nº del proyecto: #28433998

Sobre el proyecto