Expert for STM32 Motor Control Workbench with STEVAL-SPIN3201

$25-50 USD / hour

Cerrado

Publicado

hace casi 4 años

$25-50 USD / hour

Hello, I need a freelancer expert to handle (consult and remote assist) troubleshooting STEVAL-SPIN3201. Here is the issue description: We configured the motor according to datasheet in the STM32 Motor Control Workbench, however when starting the motor from Motor Control Workbench UI and measuring the phase with oscilloscope, we see constant PWM on all three phases regardless to the HAL sensors output. See the attached image of the scope - channels 1,2,3 are phase voltages relative to ground channel 4 is one of the HAL sensors.

Electronics

Electrical Engineering

Microcontroller

Engineering

Circuit Design

ID del proyecto: 26583580

Información sobre el proyecto

5 propuestas

Proyecto remoto

Activo hace 4 años

¿Buscas ganar dinero?

Dirección de email

Beneficios de presentar ofertas en Freelancer

Fija tu plazo y presupuesto

Cobra por tu trabajo

Describe tu propuesta

Es gratis registrarse y presentar ofertas en los trabajos

5 freelancers están ofertando un promedio de $35 USD /hora por este trabajo

@makeideaalive

Hi! I recently have done a similar project. I worked on medical device which has a bldc motor with STSPIN32F0 as microcontroller. I was configuring motor in Motor Control Workbench. I have a lot of experience with brushless motor. I developed many algorithm for control them like trapezoidal commutation sensorless or with hall sensor, field oriented control with encoder feedback and more. Check my portfolio and message me to determine the details.

$30 USD en 40 días

0,0

(0 comentarios)

1,9

@mustafackmk01

Hello, I master this development board and software. However, I used several boards of the ST. I can help you best.

$40 USD en 40 días

0,0

(0 comentarios)

0,0

@ouseppachacr

I have worked in the STEVAL - SPIN3201 board and i have this board with me.I have seen the cro pwm image.i can describe more about that through private chat.

$28 USD en 10 días

0,0

(0 comentarios)

0,0

@maheshrsharma8

I have excellent experience in motor control algorithm development on STM32 workbench .i developed the drivers for MOTOR CONTROL ac,stepper,dc,servo and all other .I developed this type HAL sensors with single and 3 phase control for motor control drives

$29 USD en 40 días