LED board design
$25-50 USD / hora
Board design and PCB layout for an LED driver using the following technologies: CAN bus, ARM based PSoC, LED drivers, Raspberry Pi
Nº del proyecto: #14491923
Sobre el proyecto
29 freelancers están ofertando un promedio de $39 / hora por este trabajo
Dear Sir, If you are looking for an highly skilled hardware engineer, I believe that I am the one who you're looking for. I am also an experienced PCB designer who has over 16 years design experience on complex PCB Más
Hi I am an expert electronics engineer with more than 8 years of experience. I have experience in design and firmware development of integrated PCB boards, I have used the ARM processor Raspberry pi and almost all oth Más
Hello I have experience in designing electronics circuits and can make your project. I will make your project practically on breadboard and will provide you circuit, code and PCB design along with gerber files. I will Más
Hello Sir/Madam, I am Anthony Perera from Sri Lanka and I have multiple degrees on Engineering field. Why you should hire me ? * I am a FULL TIME freelancer and once a project Más
hello,how are you. i read your bid carefully. i am pcb, arduino, raspberry pi expert and have full experience for 10 years. c/c++ language is my top skill. i can provide most quality and high speed. if you want to Más
Extensive HW design and layout experience at many levels, including CAN (standard and non-standards use), control circuits, and instrumentation.
I have good history over raspberry. Lot of projects software and hardware. But tell me, what should a can bus do on a leds driver?
Ready to start. Please initiate chat session to discuss the details........................................................
Hi, Please share your all project requirements/task expected from us, so we can give you a correct timeline. We have PSOC-4 and PSOC-5LP kits for testing purpose. And not worked on Raspberry Pi before. About u Más
Hello, Hope you are doing great..! I have carefully reviewed the requirement. I am very much interested in this project and would like to work with you on your important project. Please have a look at my profile a Más
Hi, We are leading Embedded & VLSI company in India. We have engineering team having more than 7 years of experience. We have completed more than 60 board designing. We delivered embedded board with Microprocess Más
Hello, We have accomplished 90% of the project which is similar of your requirement. All we need 10% customization as per your requirement set and specifications. I want to discuss in personal chat in order to explore Más
I will eventually need a little bit more information on how you want it to look, where it's going to be and how you want your devices to be connected, but otherwise... Let's do this!
Hello, I am Nancy McDonald we have 13 + years experience in this field. I can assure you 2 months support & service after completion of the project. We have in house PCB design & fabrication. As the provid Más
I have 1 year experience on CAN protocol, and i have been working on ARM cortex-M4 which supports CAN, I have enough experience on Led drivers and all other components that are mentioned in this project.
Hello, I've gone through your project carefully. After reading over your application description this looks like a perfect fit for my skill sets. We are an experienced C#/C++, .NET developer team. We have 7 years Más