Project Description:
I have drawings of product. I need the design simplified to allow for less expensive mass manufacture, The project is to improve design;
- to be mass manufactured
to be lighter and smaller and simpler manufacture
- have lighter frame materials specification ( suggested profiles etc)
- to utilize pipe bending instead of cut and welds.
- re-design foot piece for less expensive solution with easier manufacture
- provide solution of movement arm instead of being moved by an electronic actuator to manual operation ( ratchet, gears, counterbalance, etc) that allows movement by user on bed . Movement are need to be locked into position and to lower slowly
- Note movement arm needs to be evaluated as to stressors
- provide simple system of movement arm from 30degrees to 150 degrees that will give movement around end of bench
- to have bench hinged section at rear of "seat" to reduce bench length during transportation etc. This needs to move through 180 degrees from vertical and lockable at 0, 90 and 180 degrees