Brief Intro of company business for whose website flash components are required.
Printed circuit board manufacturer, pcb manufacturing, pcb supplier, Single sided, Double Sided Plated Through Hole (PTH) Printed Circuit Boards (PCB), and multi layer pcb.
We require following flash movies to be built. These should be optimized for running on internet.
Flash Intro (Typical duration is about 20-30 seconds with about 5-10 slides)
The suggested sequence will be as follows:
1. Large logo and strap line, which then reduces in size
2. Drawing of a printed circuit board (PCB), ie tracks leading to holes/pads which could be a line diagram which when drawn changes into a colour picture of a circuit board. Electronic components are not to be drawn as they only make the boards themselves.
3. Approx 6 to 8 slides of images and text promoting the benefits of dealing with COMPANYNAME.
4. The final scene to be navigation to the main website pages in an oval/toroid shape like in the attachment “a1”. The idea they have is that this spins in to place in the centre of the Flash Intro area and then when you hover over a menu item it moves out (like the Visitors segment below) then if you click on the segment it takes you to that page. If you have any better suggestions that would suit this industry then let us know.
Flash Header (Typical duration is about 10-15 seconds with up to 8 slides)
This will be up to 8 slides with images and words (likely to be similar to those in the Flash Intro that appear after the circuit board animation and before the final animated graphical navigation.
Other Flash – Flash Presentation of manufacturing Process.
1. This Flash presentation will be embedded in a webpage that will go through the whole manufacturing process from start to finish, where each scene has image and text and maybe the start is a flowchart showing the overall process).
2. There will be a Flowchart always visible on the right hand side of the presentation area with approx 8 steps. As the process steps through each step, the flowchart item will change colour eg maybe the active item goes from blue background to yellow.
3. During each step there may be up to 3 images and sets of words appearing in the main presentation area to the left. Some of these images will be circuits board examples and they like the idea of the boards “flying” in and getting bigger before it stops. Any suggestions would be appreciated.
4. The presentation should be able to run automatically or if you wish to go directly to one section then you should be able to click on the specific part of the flow chart to take you to that section.