IP67 PCB Case Design

I need a PCB case with following characteristic: - It should be fully water resistant (IP 67). - It should hold one battery size cr123,(1/2 AA) . Proffered to access to the battery without any screwdriver - Case should have 2 external holes for sockets: 1 micro USB female waterproof connector + female Miniature waterproof micro connector for an external device with minimum 3 pins.(this connector is not designed yet but 3 pin headers are considered near the USB port, can be seen in stl file. any suggestion for low cost connector is welcomed, miniature water proof gland also is accepted.) -Case should have a slot for inset & remove a micro SD card. It should be accessed without screwdriver; also it should not defeat the water proof. (One idea for the location of SD card could be behind the battery) -stl is attached - PCB has 1 reset switches (miniature push button, tactile)/ required inserting a pin into a hole for reset (this is actually a factory reset switch) - PCB has one small LED, SMD type and to be viewed from outside. - It is preferred to have minimum number of door on the PCB case. - 3d files to be transfered to client in solidworks format