Amibroker AFL Coding and Alteration

Will provide a AFL . (1) 3 Targets - to add for exits ( based on ATR) - Toggle selection from Inputs ( to select any 1 target) (2) Stop Loss - exit when Hit ( based on ATR) (3) Trail STOP LOSS - exit when trail stop loss hits NOTE : There will be 2 modes of entry and exit ( 1 which already coded, other as below ) If the Target / and /or is selected along with the ENTRY MODE (1OR 2) , then the STOP/TRAIL STOP AND TARGETS get activated along with the Entries. (4)Currently afl gives a buy setup (TRIGGER BAR) then a valid buy when the bar goes above the "trigger bar" (same for short) - so 1 more modes to add - for Buy , sell, short , cover . (a) Entries at the trigger bar and not after the cross of it and exit at the Reverse setup(trigger bar of the short setup) . Entry at buy setup ( trigger bar ) and short at the sell setup ( sell side trigger bar ) - means trigger bar to trigger bar reversal entries. (5) all the codes should be added as proper buy-sell- short- cover conditions, which will also be effective in the scanner, explore and the tester ( which are already existing in the existing current afl) (6) The Milestones will be opened in 2 stages, and once the maximum work is completed, please submit for check and then MILESTONE 1 will be released, the when the final submission is checked for all debugging etc, the 2nd milestone will be released. (7) Please offer a price separate for a simple dashboard - showing all entry / exit / targets / stop loss/ trail; stop loss levels .