Design a USB device + software that...

min $50 USD / hour

Cerrado

Publicado

hace casi 12 años

min $50 USD / hour

Produce a USB device + software where the software could constantly capture a desktop, pass it on to the device, which would then process the stream (processing might mean passing it on to another device for rendering, storing it to mass storage, etc…). The device would not require any installation, running the software would be enough to do everything. The software should run even when the user only has restricted access rights to the computer. Must run on Windows and Mac, optionally Linux too.

Electronics

Mac OS

Windows Desktop

ID del proyecto: 1693142

Información sobre el proyecto

4 propuestas

Proyecto remoto

Activo hace 12 años

¿Buscas ganar dinero?

Dirección de email

Beneficios de presentar ofertas en Freelancer

Fija tu plazo y presupuesto

Cobra por tu trabajo

Describe tu propuesta

Es gratis registrarse y presentar ofertas en los trabajos

4 freelancers están ofertando un promedio de $58 USD /hora por este trabajo

@MiddayNick

I am a Mac OS and Windows system developer. I could help you with the project.

$50 USD en 160 días

5,0

(39 comentarios)

7,8

@baobui

Hello. I can do it. Please check PMB

$50 USD en 20 días

4,9

(6 comentarios)

5,5

@RLT

Dear Sir, We are Reserach and Development company whose working area are : -Digital Motor Control -Analog Design -Electronic Design -Power Electronics -PCB design -Embedded system -Matlab -Simulation of hardware For each concept descriptions are as follows: Digital Motor Control: -3-phase induction motor vector control drive -Flux estimation algoritm generation -DSP(TMS320) implementation on motor drive -Low speed application -Torque and speed loop generation -Control algoritms Analog design -Low power distribution -Noissless special opamp based analog circuits -Analog filters -Orcad simulation of several circuits Electronic Design -RF transmitter and receiver -Bluetooh reader and transmitter -Magnetic reader Power Electronics -Implementation motor drive -AC/DC converter -DC-DC converter -Battery charger -Solar inverter -Renewable Energy simulations -Uninterruptle power supplies PCB design -Schematic design by Altium -PCB design by Altium -Power board design -SMPS board design Embedded system -PIC18,PIC24,PIC30 and dsPIC applications -Ardino -MSP430 -Atmel -DSP(Texas Instruments) -Renesas Matlab -Power Electronics simulation -Motor drive -Wind Energy -Solar Energy -Control applications Simulation of Hardware -Orcad Simulation(TI,National, Linear Tech, Maxim libraries) -LTI -National -Matlab Very important Note: References attached. Please look excel file to see projects which we made until now! Hido

$50 USD en 15 días