need two simple send receive programs for arduino.
RF transciever used is NRF24L01+,
first program has to send "hello word"(anydata) to reader and must go to sleep mode, then wake up and send again, and so on.
second program has to send "hello world" only after receiving a request from reader, program should wake up>start listening>if there is request from reader >send hello world> and go sleep, then wake up and over and over again.
so basicaly two algorithms first is called Tag Talks First(is when node sends data autonomously)
and second is called Reader Talks First (is when node sends data only after receiving request from reader)
1) wake up>send>sleep>wakeup>.....
2)wake up>listen>if receive>send>sleep//// otherwise sleep>wakeup>......
receiver program control can be implemented by using serial port.
for example. I send "1" and then node sends me his hello world.
Hi,
I can give you the sketch codes of these 2 algorithms in less than 24hours.
I ll also provide a live video demonstraiton of them running.
Code will be very well commented to allow further modification at your end if you want.
Of course you only release payment upon job completion.
Contact me back if interested.
Cheers
RM222 MYR en 1 día
5,0 (5 comentarios)
4,3
4,3
4 freelancers están ofertando un promedio de RM1.035 MYR por este trabajo
Hello! I have experience programming in C / C + + for almost 20 years. Devices based on Arduino, I'm doing more than 3 years.
I have experience making "smart house" on the Arduino.
More, I have experience in:
- making hydroponics installations on Arduino
- the control system with LED lights for plants light
- equipment for the reality-show "Treasure Rom"
- Access Control Systems for printing equipment with RFID
I am ready to write a program for Arduino and provide a complete description of the device.