Thank you for your speedy reply.
Picking up where we left off, these are the details for the bags that I want done:
Luger: The first bag follows the standard design that i sent you. The outer section (the part that people see) is made from leatherette. Back part (the part that touches the wearers back) should be made from upholstery. The bags should have no outside compartment as I want it to have a very sleek look. It should be around the same size of an average school backpack. The inside of the bag should be lined with neoprene to make it waterproof. The inside colour should be black or light green. All the compartments should be located on the inside of the bag. There should be a 15.6" compartment placed in the middle of the inner back of the bag. This compartment is to hold laptops. Attached to that compartment should be a smaller and slender compartment to hold the laptop's charger. Beneath those compartments I want a horizontal compartment to hold writing utensils like pens and pencils. At the inner side of the bag I want a compartment that is slim but can stretch to hold perfectly a Samsung galaxy note 4. At the bottom of that compartment there should be a small hole for the USB charger to fit through to charge the phone while it is still tucked away safely in its compartment. This hole should also be at the bottom of the bag so that the USB can stretch from an outside socket and go through the bottom of the bag and through the bottom of the phone compartment. Attached to the phone compartment should be a smaller compartment to hold the phone charger. At the other side of the bag on the inside there should be a water bottle compartment. I also want to include a 12" cushion. This cushion should be removable and strapped over the laptop compartment. All inner compartments should have zips to seal all the contents held inside. All compartments should be made from neoprene (same material used to make a scuba diving suit or a laptop sleeve). The inside of the bag should be lined with LED light strips that go all the way around the circumference of the inside of the bag. The light strip should be rechargeable and illuminates the entire inside of the bag when it is dark so that contents can be located easier.
The specifications of the bag are as follows:
2. bottom piece-23"
3. top piece lenght-27"
4. top piece width-4"
5. length of bag down the middle-18 1/2"
6. width of bag across the middle-12""
Inputs: What inputs do I need to provide for you to generate the CAD drawing of the bag I want
Output: I want to start manufacturing my bags as soon as possible, but I need a computer generated image to send to my manufactures. I want you to generate 3D models of the bags based off the instructions I give
Turnaround Time: I want you to generate the 3D model as soon as possible. How soon do you think you can get it Done?