ANSYS static structural analysis done on a bending shaft (budget $100)
$30-250 AUD
Cancelado
Publicado hace más de 5 años
$30-250 AUD
Pagado a la entrega
I have a round shaft that I need analysed on ANSYS properly. I need the shaft supported so it may get longer, but never shorter (like a bolt with no pretension applied). It will have two compression supports and two combined loads (axial and radial) applied near the centre, so it simulates the type of loading you would see in the assembly picture. I need a quad mesh and a convergence of less than 2%. If you can do this for me I have some other ANSYS work also available (please be aware that this is not an entry level project and requires ADVANCED ANSYS skills).
Hi. I'm master. Check my profil and send me message please.
# I draw with an engineering approach.
# SolidWorks
# AutoCAD
# 3dsMAX
# ANSYS
# Fusion 360
# MS Excel
# MS Word
# MS Office
# C++
# Java
600+ character per minute.
$100 AUD en 1 día
5,0 (12 comentarios)
4,3
4,3
3 freelancers están ofertando un promedio de $104 AUD por este trabajo