pulse test
$750-1500 USD
Pagado a la entrega
I'm going to looking to design a circuit that could perform double pulse test (dynamic switching, gate charge, and body diode commutation) and destructive tests (avalanche and short circuit test) for Sic and GaN power devices. The setup will be built from scratch, including safety circuit, gate driver, power supply converter (from mains to circuit), the mainboard (with capacitor banks to charge the circuit up to 400V, 800V, 1200V), and a daughter board to mount the Device under test.
The setup will also include an oscilloscope, a power supply, an arbitrary waveform generator and a computer with LabVIEW software
Nº del proyecto: #20789697
Sobre el proyecto
7 freelancers están ofertando un promedio de $1286 por este trabajo
Amount is not correct, I’ll do it in much lesser amount. Freelancer isn’t allowing me to put lesser amount than $750. I’ll only handle LabVIEW software development.
hi sir as i am computer engineer and Labview expert (CLA) certified so may i can help you achieving your target thanks
Hello, Good day, I am Dhamodharan. I have read your requirement. I am interested to take up your project. I have 10+ years of experience in Electronics hardware and software development and testing. I would like to di Más