Dear Sir, I am working as an assistant manager of design in the mechanical R & D department with a total of 9 years of Experience. Working on the consumer prototype cad design and development of Pulveriser, molded plastic material analysis,3D print, product simulation, DFMEA, and CFD analysis of Cyclone and duct with Mechanical properties calculations.
Previously worked as an sr component Engineer in the Aerospace department, designing small precise aerospace components.
A similar Experience is listed.
1. CFD Analysis, Calculation of the energy, velocity, and Temperature with Sloshing effect of Wave Water for Sea Powerplant.
2. Create a Call Station Enclosure prototype with Raspberry pi Circuit (Design, Manufacturing, Electronic circuit, Assembly, and Functionality Checked)
3. Prototype of Small Air Fuel valve for Jet Engine (Jaguar).
4. Turbine Propeller blade design and flow analysis.
5. CFD and Deformation analysis of Battery protection cover from Water Spray pressure.
I can work daily for 5 hours on this project and will complete it in 2 days.
Software: Solid Works, NX, FLOWEFD tool for CFD Analysis, MATLAB & Auto Cad
Please feel free to message me for further discussion & negotiation.