Arduino Programming Needed
₹600-3000 INR
Pagado a la entrega
We are looking for someone to program arduino for our application. The application involves continuously weighing 1 Load Cell and when the load matches or exceeds the set grammage, it needs to turn on a relay. While it hasn't achieved the set weights, it needs to turn on another relay output. Also, it needs to accept a relay input which tares the load cell. Once it receives the tare command, it needs to start again. Please see the steps mentioned below.
1. Set the Grammage using the Keypad on the LCD Shield
2. Wait for Tare signal.
3. Once Tare Signal received, after the signal is turned off, there should be a delay of 5 seconds(Or Whatever we program) to start Relay 1.
4. Then wait for grammage to be achieved.
5. Once Grammage achieved, switch off Relay 1 and turn on Relay 2.
6. Go to Step 2 Again.
You need to program arduino with the 1602 Keypad+LCD Shield and a HX711 Load Cell. Please feel free to ask if you have questions. Thanks.
Nº del proyecto: #13432132
Sobre el proyecto
8 freelancers están ofertando un promedio de ₹5958 por este trabajo
Hello. Im designing different electronics devices, mostly based on avr, arm MCUs and boards with them like arduino, stm-discovery etc. (autopromotion^)) Easy and fast task
Hi! I am an Electrical Engineer with specialization in Embedded systems and electronics. I have more than 3 years experience with Arduino development boards. I have understood the requirements of your project Más
Hello. I have rxpirirnce with Arduino more then 3 years. Alredy have projects with HX711, relays control and 1602 lcds.
Hello, Deep Kapadia is here from Ahmedabad, India. Professionaly I'm Embedded System Developer (working in the domain of Industrial Instrumentation). As per your need I have experience with Arduinos, HX711 - load ce Más