ATMEL programming

hi i can do it...

Custom Software Development - <b><i>Removed by Admin</i></b>

My greetings, kindly see private message. thanks in advance.

hi there, i can do it

Hi. I can do it. THanks

Hi.I can do this.

It would require Internal frequency calculations and i have been doing such calculations for my robotics applications. Will do.

I have done a lot of work on Atmel cores.

Dear Sir, Please consider me for your project.

Dear Sir, We are Reserach and Development company whose working area are : -Digital Motor Control -Analog Design -Electronic Design -Power Electronics -PCB design -Embedded system -Matlab -Simulation of hardware For each concept descriptions are as follows: Digital Motor Control: -3-phase induction motor vector control drive -Flux estimation algoritm generation -DSP(TMS320) implementation on motor drive -Low speed application -Torque and speed loop generation -Control algoritms Analog design -Low power distribution -Noissless special opamp based analog circuits -Analog filters -Orcad simulation of several circuits Electronic Design -RF transmitter and receiver -Bluetooh reader and transmitter -Magnetic reader Power Electronics -Implementation motor drive -AC/DC converter -DC-DC converter -Battery charger -Solar inverter -Renewable Energy simulations -Uninterruptle power supplies PCB design -Schematic design by Altium -PCB design by Altium -Power board design -SMPS board design Embedded system -PIC18,PIC24,PIC30 and dsPIC applications -Ardino -MSP430 -Atmel -DSP(Texas Instruments) -Renesas Matlab -Power Electronics simulation -Motor drive -Wind Energy -Solar Energy -Control applications Simulation of Hardware -Orcad Simulation(TI,National, Linear Tech, Maxim libraries) -LTI -National -Matlab Very important Note: References attached. Please look excel file to see projects which we made until now! Hido

I can do that, sir.

Hi, I have done similar stuff with Atmel before...

Hello Sir, Expert in microcontroller programming. Can do it for you and take up your job immediately. Thanks. Freelancer

This will be done in a few minuites. Can you advice on the programming language, Assemble of C, what compiler are you using?

Hi! I have a great experience in assembler programming. Only on this language subroutine will be economic as possible with clock cycles. I can do it.

Hello, I ll do it. Have similar experience to this.

Hi, I can do this project. I've done a lot of work on signal processing and numerical analysis. Good at both dsp and mcu programming.